12-29-2016, 09:35 PM
180 degree stainless steel elbow product descriptionStainless steel elbow in the course of the use of its products in a wide range of areas can be in the oil, as well as the hydropower industry plays a very important position in the processing of stainless steel material in the process can also save a lot of unnecessary costs . Stainless steel elbow in the operation of assembly welding will become more convenient, the equipment in the process of processing products need to pay attention to the product must not lead to corrosion due to heating the situation, so in the process of welding the current must not be too Large, the arc length should not be too long.stainless steel sheet and coil supplierBends in the processing of cracks in the main reason is that in the process of heating bending, when more than a certain level of deformation temperature will appear after the deformation of the product will appear directly outside the micro-cracks, and the situation and Processing materials are related. In general, the length of cracks can be mainly generated in the direction of stress and then perpendicular to the austenite grain boundary. After bending, the pipe will recrystallize directly through its heat treatment, This allows the microcracks to be converted to crystal pulls. Bend in the production process is also often encounter the problem of folding, there is such a problem that the product is unqualified, if the sales will give customers trouble, so the production process in accordance with its standards for effective Of production.Stainless Steel Sheet Price In ChinaNow the processing technology is very advanced, the use of products to our lives a lot of convenience, but the bend in the process of processing will also have some minor problems, such as processing temperature if more than a certain value, the surface of its products There will be a certain degree of deformation. So that the bend will appear on the surface of many of its small cracks, in fact, such a problem not only because of its temperature reasons, it may be due to the problem caused by processing of materials in the process of production if the high-speed deformation on the Will directly lead to damage to processing equipment.hollow section Seamless Stainless Steel PipeThe crack length on the elbow surface can reach its vertical axis perpendicular to the grain boundary. After the heat treatment, the product needs to bend effectively, so that the microcrack on the surface of the product will directly become its crystal pulling. During the use, the anti- Tensile strength in the room its temperature is not affected. Bending process in the process of bending if its mechanical properties and wall thickness changes will have a direct impact on the quality of its products in the process of processing its technical requirements is very important in the processing of the process must ensure that The degree of bending of the product and the processing temperature. Most of the elbow surface cracks are due to the process of heating by its temperature, in the course of the use of the higher the temperature of the micro-cracks will increase, a small part of the reason is because the heat when bending Resulting in product surface micro-cracks. Before the bend in the process of processing the material used in most of the iron, but such materials in the processing of the process there have been many drawbacks, and now the economy continues to develop, the product processing technology is also continuous progress, Processing materials also become diversified.metal sheet 420 stainless steel coil
Stainless steel mirror panel